[DNR]The digital noise reduction function reduces noise automatically under the condition of low illuminance. Selectan effect level “High” or “Low” for the digital noise reduction.• High: High DNR, increases afterimage• Low: Low DNR, reduces afterimage• Default: High[Stabilizer]Select “On” or “Off” to determine whether or not to activate the image stabilizer.• Default: OffIMPORTANT• If “On” is selected for the image stabilizer, the view angle will become narrower and the resolutionbecomes lower. When “On” is selected, check the view angle and resolution at camera installation.The image stabilizer function may not work for the following photographic subjects:– Dark subject– Less contrast subject (e.g. white wall)– Short cycled image shaking such as mechanical vibration– Large amplitude image shaking• Image stabilization may not be effective in the following case.– When a parameter other than “Off(1/30s)” is selected for “Auto slow shutter”[Chroma gain level]Adjusts the chroma level (color density).When the cursor is moved in the “+” direction, the colors will become thicker. When the cursor is moved in the“-” direction, the colors will be thinner. Click the [Reset] button to reset the color to the default.• Default: 128[Aperture level]Adjust the aperture level (outline compensation).Images will be sharper when the cursor is moved in the “+” direction, and will be softer when the cursor ismoved in the “-” direction. Click the [Reset] button to reset the color to the default.• Default: 15SW396SC386 /20SW395SC385[Pedestal level]Adjust the black level of images by moving the cursor.When the cursor is moved to the “+” direction, images will become brighter. When the cursor is moved to the“-” direction, images will be darker. Click the [Reset] button to reset the color to the default.• Default: 128[Close] buttonClick this button to quit the “Image adjust” setup menu.11.6.2 Configure the settings relating to image quality (“Imageadjust” setup menu) (WV-SC384 Only)Click the [Setup>>] button of “Image adjust” on the [Image/Position] tab of the “Image/Audio” page.(®page 94) The settings relating to image quality can be configured with the setup menu displayed in a newlyOperating Instructions 10111 Configure the settings relating to images and audio [Image/Audio]
