Panasonic WV-CW970 Operating Instructions Manual

Also see for Super Dynamic III WV-CW974: Product catalog Product catalog Brochure & specs Specifications Operating instructions

Contents

Panasonic WV-CW970 Operating Instructions Manual Manual pdf 40 page image

4. Input an area title.The text input procedure is the same as that forcamera ID input.See steps 3 through 5 under “Camera ID Settings”on page 24 for information about inputting the textfor the area title and specifying its position on thedisplay.5. Repeat steps 1 through 4 for the other areanumbers, if you want.(13) Tilt Angle Setting (TILT ANGLE)Selecting 5° for the TILT ANGLE setting allows tiltingpast horizontal, in the range of -5° to 185°.1. Move the cursor to TILT ANGLE, and then tilt thejoystick left or right to toggle the setting between 0°and 5°.Notes:• Zooming to WIDE while 5° is selected for theTILT angle setting will cause the upper half ofthe picture to become hidden.• With certain subjects, AGC (gain control) cancause the image to become white.(14) Cleaning Settings (CLEANING)This camera uses a "slip ring" for transmission ofelectrical power and signals. A dirty slip ring can causedeterioration of picture quality and generation of noise.The cleaning function performs cleaning approximatelyonce a week to keep the slip ring clean.1. Move the cursor to CLEANING, and then tilt thejoystick left or right to toggle it on and off.The text CLEANING appears in the centre of thescreen while the cleaning process is beingperformed.Note: Select OFF for CLEANING when the systemcontroller uploads or downloads the preset data.This protects against the download or upload failuredue to start up of the cleaning process.6. Use the joystick to select an area title displayposition, and then press the MON (ESC) button.This registers the area title display position andreturns to the area title (NESW) setting menu.Note: The area title is always displayed under thecamera ID. If you specify different display positionsettings for the camera ID and the area title ID, thearea title ID display position setting is used for both.(2) When ON (USER) is selectedAfter selecting ON (USER), you can use the area title(USER) setting menu to configure detailed settings.You can use the following procedure to configuredirection settings, and to input text associated with aparticular direction indicator.1. Move the cursor to 1, and then press the CAM(SET) button.This will display the position setting menu. An asterisk(*) to the right of an area title number indicates that italready has an area title assigned to it.If the there is already text associated with thedirection you selected, it will appear under thecross mark (+). If there is no text associated withthe direction, only the cross mark (+) will bedisplayed.2. Adjust the camera orientation (pan and tilt), zoom,and focus.Perform steps 1 through 4 under “(1) When ON(NESW) is selected” on page 39.3. Move the joystick to the right to align the cursor withthe title display, and press the CAM (SET) button.This will display the area title setting menu.In the example screen shown in step 1, NORTH Ois the title name of area title number 1.-40-FLOOR 1N**AREA TITLE(USER)**NORTH2345678RET TOP RESET1*AREA TITLE 1123456789ABCDEFGHIJKLMNOPQRSTUVWXYZ().,'":;&#!?=+-*/%$SPACE---- POSI RET RESET................0→PUSH SET**DIRECTION(USER) 1**PAN/TILTZOOM/FOCUS+NORTHRET TOP DEL→PUSH SETFLOOR 1NORTH