63EnglishUsing NetworkFunctionThis unit has a network function and you can control theDisplay connected to the network using your computer.Necessary environment forcomputers to be connectedFirst of all, confirm your computer whether it has a wiredLAN or a built-in wireless LAN.Before connecting the Display to the computer, be sureto check the following settings.Check 1: About LAN cable● Is the cable connected properly?● Use LAN cable that is compatible with category 5 orabove.Check 2: LAN settingsComputer with a built-in LAN function● Is your LAN switched on?Computer without a built-in LAN function● Is your LAN adapter recognized properly?● Is your LAN adapter switched on?● Install the LAN adapter driver beforehand.For details on how to install the driver, refer to theinstructions accompanying the LAN adapter.■ About Web BrowserWeb Browser is necessary to use WEB control.● Compatible OS:Windows XP / Windows Vista / Windows 7 /Windows 8,Mac OS X v10.4 / v10.5 / v10.6, OS X v10.7 / v10.8● Compatible Web Browser:Internet Explorer 7.0 / 8.0 / 9.0 / 10.0,Safari 4.x / 5.x / 6.x (Mac OS)Example of network connectionNote● To use the network function, set each item in[Network control] and make sure to set [Networkcontrol] to [On].(see page 53)When it is set to [On], power indicator lights orangeunder the condition of power “Off” with remote control(stand-by state).■ LAN Terminal connectionBack of the DisplayCOMPUTERLAN TerminalLAN cable (not supplied)Hub or broadband routerNote● For LAN cable, use shielded cable, otherwise picturenoise may be caused.● Make sure the broadband router or hub supports100BASE-TX.● Touching the LAN Terminal with a statically chargedhand (body) may cause damage to the device due toits discharge.Do not touch the LAN Terminal or the metal part ofthe LAN cable.● For instructions on connection, consult your networkadministrator.