|
33EnglishAdjusting Position1 Press to display the[Position] menu.0000000PositionDefault DefaultAuto setupH-positionH-sizeV-positionV-sizeDot clockClock phaseClamp positionOver scan On2 Select the item to adjust with .● Unadjustable items are greyed out.Adjustable items differ depending on the inputsignal and the display mode.3 Adjust with .4 Press to exit from adjustmode.■ To return to the previous screenPress .■ To reset to defaultsPress while the menu is displayed, orpress when [Default] is selected, then thesettings will be set to factory settings.Note● [Position] cannot be adjusted during 4 Input multidisplay.● [Position] is invalid during 4K picture mode. 4K formatsignal will be displayed filling the entire screen.● For 4096 × 2160 signal (2048 × 1080 signal), the leftand right side of the picture will be cut off according tothe pixel number of the panel.● Settings for [Position] are memorised separately foreach input terminal.Setting [Position] when the display is installedverticallyWhen adjusting, please note that even when thedisplay is installed vertically, setting directions ofposition / size are the same as that of horizontalinstallation.Auto setupWhen inputting a PC signal as an example, [H-position]/ [V-position], [H-size] / [V-size], [Dot clock] and [Clockphase] are automatically corrected.This setting is enabled under the followingconditions:● When inputting an analogue signal (PC):This setting is enabled when [Component/RGB-inselect] (see page 43) in [Signal] menu is [RGB].● When inputting a digital signal (HDMI/DVI-D/DisplayPort):A PC format signal enables this setting.This setting is enabled when the signal is notPC format or [Over scan] (see page 34) is [Off].[H-size] / [V-size] is not automatically adjusted.While displaying the picture of the correspondingsignal, select [Auto setup] and press .Using Remote ControlPress .When Auto Setup does not work, [Invalid] isdisplayed.Auto modeWhen the [Auto setup] is set to [Auto] in the [Options]menu (see page 61), automatic position adjustmentstarts:● When the display power is turned ON.● When the input signal is switched.Note● [Auto setup] is invalid during 4K picture mode.● When the dot clock frequency of an analogue signalis 162 MHz or higher, [Dot clock] and [Clock phase]cannot be automatically corrected.● During digital signal input, auto setup for [Dot clock]and [Clock phase] cannot be made.● Auto Setup may not work when a cropped or darkimage is input. In such case, switch to a bright imagewith borders and other objects are clearly shown,and then try auto setup again.● Depending on the signal, out of alignment mayoccur after Auto Setup. Carry out fine tuning for theposition/size as required.● If Auto Setup cannot set properly for verticalfrequency 60Hz XGA signal (1024×768@60Hz,1280×768@60Hz, and 1366×768@60Hz), pre-selecting the individual signal in [XGA mode] (seepage 43) may results in correct Auto Setup.● Auto Setup does not work well when a signal suchas additional information is superimposed out of validimage period or intervals between synchronizing andimage signals are short, or for image signal with tri-level synchronizing signal added.● If Auto Setup does not work well, select [Default],press , and then adjust the position/sizemanually.
|
