English58Onscreen displaySet to display / hide the following Onscreen display.● Power on display● Input signal switch display● No signal display● MUTE display after displaying the menu screen● MUTE and off timer remaining time display after is pressed● Off timer remaining time display when 3 minutesremaining[On]: Displays the Onscreen display.[Off]: Hides the Onscreen display.Initial inputAdjusts the input signal when the unit is turned on.[Off] / [HDMI1] / [HDMI2] / [HDMI3] / [HDMI4] /[DisplayPort] / [DIGITAL LINK] / [DVI-D] / [PC] /[SDI1]**: When a Terminal Board is installed to the SLOT, itsTerminal name will be displayed.Note● This menu is available only when [Input lock] is [Off].(see page 58)Initial VOL levelAdjusts the sound volume level when the unit is turnedon.[Off]: It will be the sound volume level which hadbeen set before the power of the unit wasturned off.[On]: Sets your preferred volume.● You can hear the changed volume regardless of yourvolume setting before opening the [Options] menu ifyou adjust the volume when [Initial VOL level] is [On]and cursor is on the menu.■ To adjust sound volume levelPress .Note● When [Maximum VOL level] is [On], the volumecan only be adjusted between 0 and your maximumrange. (see page 58)Maximum VOL levelAdjusts the maximum volume.[Off]: The sound volume level can be set up to 63(maximum).[On]: The sound volume level will not exceed theset point.■ To adjust sound volume levelPress .Note● When the [Maximum VOL level] is set lower than the[Initial VOL level], the [Initial VOL level] automaticallybecomes the same as the [Maximum VOL level].The volume display can go up to 63 regardless of thesettings.● You can hear the changed volume regardless of yourvolume setting before opening the [Options] menu ifyou adjust the volume when [Maximum VOL level] is[On] and cursor is on the menu.Input lockLocks the input switch operation.[Off] / [HDMI1] / [HDMI2] / [HDMI3] / [HDMI4] /[DisplayPort] / [DIGITAL LINK] / [DVI-D] / [PC] /[SDI1]**: When a Terminal Board is installed to the SLOT, itsTerminal name will be displayed.Note● Input switch can be used when this is set to [Off].
