53English[Subnet mask]:(Subnet mask display and setting)Enter a Subnet mask when DHCP server is notused.[Gateway]:(Gateway address display and setting)Enter a gateway address when DHCP server is notused.Note● IP address will not be displayed when [DHCP] isset to [On].Entering numbers1. Select the item and press .2. Select digits with .3. Change numbers with numeric buttons (<0> -<9>).It is also possible to change with .4. Press .You can cancel the change by pressing.Select [Save] and press .Save the current network Setup.Note● To use a DHCP server, make sure the DHCP serveris started.● Contact your network administrator for details on [IPaddress], [Subnet mask] and [Gateway].● Shipping condition[DHCP]: Off[IP address]: 192.168.0.8[Subnet mask]: 255.255.255.0[Gateway]: 192.168.0.1[Port]Set the port number used for command control.Select [Port] and press to set the number.● The available setting range is 1024 - 65535.● Entering numbers (see page 53)Note● When the PJLink protocol is used, the port setting isnot necessary.[DUPLEX]Set the transmission method of the LAN environment.[Auto], [100 Half], [100 Full][Network ID]Set the ID to identify this unit.Press [Network ID] and press to set thenumber.● The available setting range is 0 - 99.● Entering numbers (see page 53)■ [Name change]The name of the Display that is shown on the networkcan be changed.Select [Name change] with and press.A B C D E F G H I J K L MN O P Q R S T U V W X Y Za b c d e f g h i j k l mn o p q r s t u v w x y z0 1 2 3 4 5 6 7 8 9! ” # $ % & ’ + – / = ?_ ` | ~ < > ( ) [ ] { } ,@ \ ˆ. ; :Name0000█Name changeOk CancelAll deleteDeleteSpace● Up to 8 characters can be set for Display name.● Entering characters (see page 71)■ [Network control]Set when controlling with the unit’s DIGITAL LINK /LAN terminal.[On]:Controls via LAN using the LAN terminal of theDisplay or twisted pair cable transmitter or viaRS-232C using the SERIAL (RS-232C) terminal oftwisted pair cable transmitter. The power indicatorlights orange when the power is turned off with theremote control (standby).[Off]:Invalidates control with DIGITAL LINK / LANterminal.(In this case, the power consumption of Standbycondition (when the power is turned off with theremote control) will be slightly reduced.)Note● Even when [Off] is selected, when the power isturned on, HDMI communication via twisted paircable transmitter becomes possible.● For the case of [On], see [DIGITAL LINK mode](see page 54)● When this is set to [On] and [DIGITAL LINK(RS-232C)] is selected in [DIGITAL LINK mode], it is notpossible to control with the unit’s SERIAL terminal.■ [AMX D.D.]Set whether to allow the Display to be detected byAMX Device Discovery.[On]:Enables detection by AMX Device Discovery.[Off]:Disables detection by AMX Device Discovery.● For more details, visit the following web site.http://www.amx.com/
