English42Setup menu1 Press to display the [Setup]menu.Setup4 Input multi display settingsNetwork settingsLandscapeSingle [HDMI1,HDMI2]SignalScreensaverECO mode settingsInput labelFunction button settingsOn/Off timer settingsDay/Time settingsHDMI 4K InterfaceDisplay orientationHigh altitude modeMenu display durationNo activity power offOSD brightnessOSD positionOSD languageOffDisable60 sec5RightEnglish(UK)2 Select the item to set with .● Menu that cannot be adjusted is greyed out.Adjustable menu changes depending on signal,input and menu setting.3 Set with .4 Press to exit from adjustmode.■ To return to the previous screenPress .4 Input multi display settingsSet 4 Input multi display function.● 4 Input multi display (see page 30)HDMI4HDMI3HDMI2HDMI14 Input multi display settings4 Input multi displayINPUT(upper-left)INPUT(upper-right)INPUT(lower-left)INPUT(lower-right)On[4 Input multi display]When this is set to [On], the display will be in“4-screen display”.The following settings will be available.[INPUT(upper-left)] - [INPUT(lower-right)]Set the inputs to display in “4-screen display”.Note● The mode set in [4 Input multi display settings] aremaintained even when the unit is turned on or off.Network settingsSet to communicate with computers via Network. (seepage 52)For details about PJLink and Network, see page 63.SignalFor Digital60.0 Hz108.0 MHz1125(1080)/60i33.7 kHzSignalSignal range1080i/PsFNoise reductionV-Freq.H-Freq.Dot Clock Freq.Signal FormatAutoAutoOffFor Component60.0 Hz-- Hz1125(1080)/60i33.7 kHzSignalComponent/RGB-in selectSyncXGA modeInput levelNoise reduction1080i/PsFH-Freq.V-Freq.Dot Clock Freq.Signal FormatComponentAutoAutoAutoOffFor RGB60.0 Hz-- Hz1125(1080)/60i33.7 kHzSignalComponent/RGB-in selectSyncXGA modeInput levelNoise reduction1080i/PsFH-Freq.V-Freq.Dot Clock Freq.Signal FormatRGBAutoAutoAutoOffFor DisplayPort60.0 Hz108.0 MHz1125(1080)/60i33.7 kHzSignalSignal rangeStream setting1080i/PsFNoise reductionV-Freq.H-Freq.Dot Clock Freq.Signal FormatAutoAutoAutoOffNote● Depending on the input signal type, an optionalTerminal Board may be required.● [Signal] setup menu displays a different settingcondition for each input signal.
