English54■ [DIGITAL LINK status]Display the DIGITAL LINK connection environment.Select [DIGITAL LINK status] with and press.-YY dB-XX dBDIGITAL LINK statusLINK statusHDMI statusSignal qualityMinMaxNo linkNo HDMI[LINK status]:1 of the followings will be displayed.[No link]:No LAN connection, etc.[DIGITAL LINK]:Connected to the DIGITAL LINK device by LAN.[Ethernet]:The PC is connected to the DIGITAL LINK terminalof this product and is LAN connected.[HDMI status]:1 of the followings will be displayed.[No HDMI]: DIGITAL LINK not connected[HDMI ON]: DIGITAL LINK connected[HDCP ON]: HDCP supported on DIGITAL LINK[Signal quality]:It is the quantified minimum and maximum numbersof errors that have occurred. The display coloursare red, yellow, or green, depending on the number.Signal quality DisplayColoursReceptionStatus-12dB or below Green Good-11 to -8dB Yellow Bad-7dB or above Red Terrible● The number is represented by yellow or red ifthe LAN cable is disconnected or the cable is notshielded.● This signal quality shows figures between thetwisted pair cable transmitter that is connectedand the display.■ [Digital Interface Box]Displays the setting menu of Digital Interface Box.Select [Digital Interface Box] with and press.Note● This function can only be selected when the DigitalInterface Box (ET-YFB100G) made by our companyis connected to a LAN terminal and its power is on.■ [DIGITAL LINK mode]You can switch the setting of DIGITAL LINK/LANterminal.[LAN]:Enables LAN communication via the Display’s LANterminal.[Auto(LAN)]:Enables automatic selection between LANcommunication via the Display’s LAN terminal andHDMI/LAN communication via the twisted pair cabletransmitter.[DIGITAL LINK(LAN)]:Enables HDMI/LAN communication via the twistedpair cable transmitter.[DIGITAL LINK(RS-232C)]:Enables HDMI/RS-232C communication via thetwisted pair cable transmitter.Note● To use the control methods shown on pages67 to 69, select [LAN], [Auto(LAN)] or [DIGITALLINK(LAN)].● Power consumption during standby is slightly largerwhen you set to any other setting than [LAN].● When [DIGITAL LINK(RS-232C)] is selected, itis not possible to control with the unit’s SERIALterminal.■ [Extron XTP]Set to [On] when connecting XTP Transmitter made byExtron to DIGITAL LINK terminal.● For more details on Extron, visit the following website.http://www.extron.com
