Panasonic TH-98LQ70U Operating Instructions Manual

Also see for TH-84LQ70U: Operating instructions

Panasonic TH-98LQ70U Operating Instructions Manual Manual pdf 43 page image

43English[Component/RGB-in select]Select to match the signals from the source connectedto the PC IN terminal.[Component] Y, PB, PR /Y, CB, CR signals[RGB] RGB signals[YUV/RGB-in select]Select to match the signals from the source connectedto the DVI-D IN terminal.[YUV] YUV signals[RGB] RGB signals[Sync]This function operates only during PC input.Setting RGB/PC sync signal[Auto]:The H and V sync or synchronized signal isautomatically selected. When both of them havesync, H and V sync will be selected.[on G]:Uses a synchronized signal on the Video G signal,which is input from the G connector.Setting Component sync signal[Auto]:The H and V sync or synchronized signal isautomatically selected. When both of them havesync, H and V sync will be selected.[on Y]:Uses a synchronized signal on the Video Y signal,which is input from the Y connector.[XGA mode]This menu is displayed when the input signal isanalogue (Component/PC). This unit supports threetypes of XGA signals with 60Hz vertical frequencyhaving different aspect ratios and sampling rates(1024 × 768 @60Hz, 1280 × 768 @60Hz and 1366 ×768 @60Hz).[Auto]:Automatically selected from [1024x768]/[1280x768]/[1366x768].Switch the setting to suit the input signal for betterdisplay depends on the angle of view or displayresolution condition.Note● After making this setting, be sure to make eachadjustment (such as [Auto setup]) on the [Position]menu as necessary. (see page 33)[Signal range]Switches the dynamic range according to the inputsignals below.HDMI1 to HDMI4, DIGITAL LINK, DisplayPort, SLOT(SDI1 to SDI4)[Video(16-235)]:If the input signal is the video range, Example: HDMIterminal output for DVD player[Full(0-255)]:If the input signal is full range, Example: HDMIterminal output for personal computer[Auto]:Switches the dynamic range automatically between[Video(16-235)] and [Full(0-255)] according to theinput signal.● [Auto] cannot be selected during the DIGITAL LINKand SLOT (SDI1 to SDI4) input.[Stream setting]This menu is displayed during DisplayPort input.Set the display method for stream of the deviceconnected to the DisplayPort terminal.[Auto]:Automatically switches to the appropriate streamaccording to the input signal.[Single stream]:Displayed as single stream.[Input level]This menu is displayed at PC IN input.Adjustment of parts which are extremely bright andhard to see.- 32 to + 32:(Level low) - (Level high)[1080i/PsF]Sets the mode of image processing most suitable forthe picture to display.[Auto]:Discriminates automatically according to the inputsignal.[i]:Displays the picture signal with IP conversionprocessing.[PsF]:Displays the picture signal with progressiveconversion processing.