Panasonic TH-43LFE8U Operating Instructions Manual

Also see for TH-43LFE8E: Operating instructions

Contents

Panasonic TH-43LFE8U Operating Instructions Manual Manual pdf 55 page image

55EnglishNetwork settingsSet when networking with a computer.[Network settings] submenu will be displayed.Network settingsNetwork controlLFE8-00OffOffOffDisplay nameNetwork statusLAN setupAMX D.D.Crestron Connected™Reset■ [Network control]Set when controlling with the unit’s LAN terminal.[On]:Controls via LAN using the LAN terminal of theDisplay. The power indicator lights orange whenthe power is turned off with the remote control(standby).[Off]:Invalidates control with LAN terminal.(In this case, the power consumption of Standbycondition (when the power is turned off with theremote control) will be slightly reduced.)Note● When using the LAN control function for “UsingNetwork Function” (page 64-72), set this functionto [On].■ [Display name]The name of the Display that is shown on the networkcan be changed.■ [LAN setup]Detailed network settings for the LAN established viathe LAN terminal of the Display or twisted pair cabletransmitter can be configured.Select [LAN setup] with and press .192.168. 0. 8255.255.255. 0192.168. 0. 110240--:--:--:--:--:--LAN setupSaveDHCP OffIP addressSubnet maskGatewayPort[DHCP], [IP address], [Subnet mask], [Gateway]Press to set [On] / [Off] of [DHCP] and press.When [Off] is selected, IP address and other settingscan be set manually.[DHCP]:(DHCP client function)[On]:Obtains an IP address automatically when aDHCP server exists in the network the Display isgoing to be connected.[Off]:When a DHCP server does not exist in thenetwork the Display is going to be connected,set [IP address], [Subnet mask] and [Gateway]manually.[IP address]:(IP address display and setting)Enter an IP address when DHCP server is not used.[Subnet mask]:(Subnet mask display and setting)Enter a Subnet mask when DHCP server is notused.[Gateway]:(Gateway address display and setting)Enter a gateway address when DHCP server is notused.Note● When [DHCP] is set to [On], the IP address, etc. willbe displayed in gray.Entering numbersI192.168. 0. 8IP address1. Select the address and press .2. Select digits with .3. Change numbers with .4. Press .You can cancel the change by pressing.Select [Save] and press .Save the current network Setup.Note● To use a DHCP server, make sure the DHCP serveris started.● Contact your network administrator for details on [IPaddress], [Subnet mask] and [Gateway].● Shipping condition[DHCP]: Off[IP address]: 192.168.0.8[Subnet mask]: 255.255.255.0[Gateway]: 192.168.0.1[Port]Set the port number used for command control.Select [Port] and press to set the number.● The available setting range is 1024 - 65535.● Entering numbers (see page 55)