Panasonic TH-43LFE8U Operating Instructions Manual

Also see for TH-43LFE8E: Operating instructions

Contents

Panasonic TH-43LFE8U Operating Instructions Manual Manual pdf 34 page image

English34filelist.datGroupID:G01PHOTO_001: R_Introduction.jpgVIDEO_001: R_Contents_Video1.wmvVIDEO_002: R_Contents_Video2.wmvVIDEO_003: R_Contents_Video3.wmvPlay contentsFor the above setting example, the following contentswill be played on repeat (loop).[Master side]1. L_Introduction.jpg (10 seconds)2. L_Contents_Video1.wmv (10 seconds)3. L_Contents_Video2.wmv (20 seconds)4. L_Contents_Video3.wmv ( *1)[Slave side]1. R_Introduction.jpg (10 seconds)2. R_Contents_Video1.wmv (10 seconds)3. R_Contents_Video2.wmv (20 seconds)4. R_Contents_Video3.wmv ( *1)*1 Played for the duration of the play time of L_Contents_Video3.wmv (Master side).Note● [Multi display settings] is not supported.■ USB memory contents checkYou can run a USB memory contents check in [USBmedia player settings] - [Scenario file check]. (seepage 56)If an error is present, the information is given with thefollowing details.A(B):CA: Name of the file with an errorB: Row with an errorC: Error codeNote● Shows leading error codes. Details of the detectederrors are as follows.Errorcode Detail of the error1. No USB memory is inserted2. scenario.dat / filelist.dat cannot be opened3. There is an error in writing scenario.dat /filelist.dat4. The play file format is not supported5. No play file exists6. It is Multi Media Player, but no group ID isspecified yet7. There are several identical file definitions8. The play time is outside the range9. The file listed in the scenario is not in thefile list10. The scenario contains 0 or over 1000play files11. There are 0 or over 1000 play files (SingleMedia Player Type3 only)12. Only the group ID is listed on the file list(Multi Media Player only)Supplementary noteThe USB memory contents check does notdetermine whether or not a play file is playable.If a file cannot be played while Media Player isactive, an error message will be displayed.When performing the synchronized playback on theMulti Media Player, check if the file is playable usingthe “Scenario File Check” for “USB Media PlayerSetting”Network environment (Multi MediaPlayer only)■ Example of setting up LAN connection and IPaddress / Subnet maskAs mentioned below, connect several units togetherwith LAN cables and set up IP addresses / Subnetmasks so that all the displays exist on the samenetwork.Master IP address:Subnet mask:192.168.10.1255.255.255.0Slave IP address:Subnet mask:192.168.10.2255.255.255.0Slave IP address:Subnet mask:192.168.10.3255.255.255.0Slave IP address:Subnet mask:192.168.10.4255.255.255.0