Panasonic TH-43LFE8U Operating Instructions Manual

Also see for TH-43LFE8E: Operating instructions

Contents

Panasonic TH-43LFE8U Operating Instructions Manual Manual pdf 18 page image

English18PC IN terminal connectionConnect a cablewhich matchesthe audio outputterminal on thecomputer.(not supplied)(Male)(Female)Shared with DVI-D IN.Mini D-sub 15p (not supplied)Conversion adapter (if necessary) (not supplied)Stereo mini plug (M3) cable (not supplied)COMPUTERThe type of computer signal that can be connected● With regard to the typical PC input signals thatare described in “Preset Signals” (see page 75),adjustment values such as for the standard picturepositions and sizes have already been stored in thisunit. You can add up to eight PC input signal types thatare not included in the list.● Computer signals which can be input are those witha horizontal scanning frequency of 30 to 110 kHz andvertical scanning frequency of 48 to 120 Hz.● The display resolution is a maximum of 1 440 × 1 080dots when the aspect mode is set to [4:3], and 1 920× 1 080 dots when the aspect mode is set to [16:9].If the display resolution exceeds these maximums, itmay not be possible to show fine detail with sufficientclarity.● In [ENGLISH(US)] OSD language, [16:9] is displayedas [FULL].Note● The PC IN terminal is DDC2B-compatible. If thecomputer being connected is not DDC2B-compatible,you will need to make setting changes to the computerat the time of connection.● Some PC models cannot be connected to the set.● There is no need to use an adapter for computers withDOS/V compatible Mini D-sub 15P terminal.● The computer shown in the illustration is for examplepurposes only.● Additional computer, cables and conversion adaptershown are not supplied with this set.● Do not set the horizontal and vertical scanningfrequencies for PC signals which are above or belowthe specified frequency range.● Component Input is possible with the pin 1, 2, 3 of theMini D-sub 15P Connector.● Change the [Component/RGB-in select] setting inthe [Signal] menu to [Component] (when Componentsignal connection) or [RGB] (when RGB signalconnection). (see page 48)Pin assignments and signal names for PC InputTerminal (Mini D-sub 15P)167839451015 14 13 12 112Pin No. Signal NameR (PR/CR)G (Y)B (PB/CB)NC (not connected)GND (Ground)GND (Ground)GND (Ground)GND (Ground)+5 V DCGND (Ground)NC (not connected)SDAHD/SYNCVDSCL