23EnglishIdentifying ControlsMain Unit43/48/55-inchmodels65-inch model●For normal use, pull out the power indicator andremote control sensor from the edge side of themain unit by operating the lever on the rear panel.Depending on the setup condition such as whenusing the multi display, store them in the main unit.Note●For normal use, pull out the power indicator andremote control sensor from the edge side of themain unit by operating the lever on the rear panel.Depending on the setup condition such as whenusing the multi display, store them in the main unit.1 Power Indicator / Remote control sensorThe Power Indicator will light.When the power of the unit is ON (Main Power On /Off switch: ON)●Picture is displayed: Green●Power OFF (Standby) with remote control: RedWhen [Network control] is set to [On] (see page55) : Orange (Red/Green)●Power OFF with “Power management” function:Orange (Red/Green)“Power management” function (see page 51)When the power of the unit is OFF (Main Power OnOff switch: OFF): No lightNoteThe unit will still consume some power as long as thepower cord is still inserted into the wall outlet.When the power indicator is orange, power consumptionduring standby is generally larger than that of when thepower indicator is red.MENUENTERINPUT+-1External Input Terminal●Connect to video equipment, PC, etc. (see page15)2●Turns the power On / Off.3 (INPUT signal selection)●Selects the connected device. (see page 27)4●Each time the the menu screen will switch. (see page 36)5<+ (Unit)> / <- (Unit)>●Volume Up “+” Down “–”●Adjusts the volume. Also, switches the settings oradjusts the level on the main screen. (see page28, 36)6< ▲ (Unit)> / < ▼ (Unit)>●Selects the setting item. (see page 36)7●Configures the item on menu screen. (see page36)●Switches aspect mode. (see page 29)