25EnglishBasic ControlsMUTEMain Power On /Off switch(Back of the unit)43/48/55-inch modelsRemote Control Sensor/Power IndicatorRemote Control Sensor/Power IndicatorAC socket outletAC cord (supplied)Operate pointing the remote control directly atthe unit’s Remote Control Sensor.Note● For normal use, pull out the remote control sensorfrom the edge side of the main unit by operating thelever on the rear panel. (see page 23)● Do not put an obstacle between the remote controlsensor of the main unit and the remote control.● Operate the remote control in front of the remotecontrol sensor or from the area where the sensor canbe seen.● Do not subject the remote control sensor of the mainunit to the direct sunlight or strong fluorescent light.1 Connect the AC cord plug to theDisplay.(see page 13)2 Connect the plug to the socket outlet.Note● Main plug types vary between countries. The powerplug shown at left may, therefore, not be the typefitted to your set.● When disconnecting the AC cord, be absolutelysure to disconnect the AC cord plug at the socketoutlet first.3 Press the switch> on the unit to turn the set on:Power-On.● Power Indicator: Green (Picture is displayed.)● When the power of the unit is ON, remote controloperation is possible.■ To turn the power ON/OFF with the remotecontrolPress the standby (ON/OFF) button to turn the Displayon.● Power Indicator: Green (Picture is displayed.)Press the standby (ON/OFF) button to turn the Displayoff.● Power Indicator: Red (standby)Press the on the unit toturn the unit off, when the power of the unit is turned onor in standby mode.Note● During operation of the “Power management”function, the power indicator turns orange in thepower off state.“Power management” function (see page 51)65-inch model