Panasonic TH-43LFE8U Operating Instructions Manual

Also see for TH-43LFE8E: Operating instructions

Contents

Panasonic TH-43LFE8U Operating Instructions Manual Manual pdf 78 page image

English78Data CloningMenu settings and adjusted values set on a singledisplay can be copied to multiple displays using a USBmemory.■ Data that can be copiedSettings and set values of [Picture], [Sound], [Setup],[Position] and [Options] menus● The following data cannot be copied. Setting isrequired for each display.Date and timeSetting for [Network settings] - [LAN setup]Display ID in [Options] - [Display ID]■ Supported device● Commercially available USB memory devices aresupported. (Those with security functions are notsupported.)● USB memory devices other than those formatted inFAT16 or FAT32 cannot be used.● Up to 32 GB of USB memory in size are supported.● Only single partition configuration is supported.Note● If the inch size for display differs, the cloningfunction does not operate. Use the common inchsize.● The remote control is used to display [USB datacloning] menu. Unit buttons cannot be used todisplay the menu.● Set the input to something other than [USB], andperform the data cloning.Copying the display data to the USBmemory1 Insert the USB memory device to theUSB terminal on the side edge of thedisplay.USBmemoryUSBterminalNote● Depending on the type of a USB memory device,it may come in contact with the periphery suchas a back cover, and cannot be attached. Use acommercially sold extension cable, or use a smalltype of a USB memory device connectable to thisunit.● If the USB memory containing the data for cloningis connected in power-on state, the [Select CopyType] message in step 5 is displayed. Select[Display → USB Memory]. Also, if the data copy isperformed, the saved data is overwritten.● Failure to save in or read from the USB memorydisplays an error message.2 Display [Setup] menu pressing.3 Select [OSD Language] with andpress for over 3 seconds.The following display appears.OptionsDisplay serial numberShippingUSB data cloningSoftware licenses4 Select [USB data cloning] withand press .5 Select [Display → USB Memory] withand press .Select Copy TypeDisplay → USB MemoryUSB Memory → Display