Entering CharactersThe dial keys are used to enter characters and numbers. Each of the dial keys has multiple characters assignedto it. To enter a character, press the appropriate dial key until the character you want appears. To enter anothercharacter that is assigned to the same key, first press (RIGHT) to move the cursor to the right.Character TablesYou can enter alphabetic characters and digits using the dial keys. Pressing a dial key repeatedly displays differentcharacters, as shown in the following tables.While entering characters, you can move the cursor with (LEFT) and (RIGHT) on the Navigator key. On theFeature Key screen, the Calls screen (in Line Buttons mode), and the Programming screen, you can delete acharacter by pressing (TRANSFER). On the other screens, you can delete a character by pressing (LEFT)on the Navigator key. For a list of available characters, refer to the following pages. The tables show you thecharacters available for each button.Note• You can switch the character table by pressing .• You can specify the length of time before a character is automatically accepted. After you enter a character,if you do not press any other buttons before the specified length of time elapses, then the character isautomatically accepted. Once a character has been accepted, pressing the same button will not changethe character, but will instead add a new character.The default length of time for automatic acceptance is 500 ms (0.5 seconds).For details about the setting, see "Display / Operation Settings (Page 121)".Table 1 (Standard mode)!ADGJMPTW(space)$? 1"B C a b c 2E F d e f 3H I g h i 4K L j k l 5N O m n 6oQ R S p q r s 7U V t 8u vX Y Z w x y z 9. , : ; 0% & ( ) #/ + — = < >£’TimesButtons@Note• A space counts as one character.Operating Instructions 155Settings and Customisation
