Panasonic AU-EVA1 Operating Instructions Manual

Also see for AU-EVA1: Manual Setup guide Manual

– 82 –Chapter 4 Operation — Menu setting contents[WHITE][AWB]Executes the adjustment of auto white balance. This can be executed when [VALUE] is set to [AWB MEMORY].The items that can be selected are as follows.f [EXECUTE], [CANCEL][VALUE]Selects the adjustment value of auto white balance.Following values are registered as the factory settings.f [ATW], [AWB MEMORY], [3200K+0.0GMg], [4300K+0.0GMg], [5600K+0.0GMg], [6300K+0.0GMg](Factory setting: [3200K+0.0GMg])@@ NOTEt [ATW] cannot be selected when the [SYSTEM SETTINGS] menu → [COLOR SETTINGS] → [MAIN] → [V-Log] is set.t [ATW] cannot be selected when the [CAMERA SETTINGS] menu → [IR SHOOTING] → [ON] is set.[ADD]Newly registers the adjustment value of auto white balance. The newly registered value can be selected in [VALUE] of [WHITE].Maximum of 12 values can be registered. It cannot be registered when there are 12 registered already.Following values are registered as the factory settings.f [2000K]…[15000K], [−10.0GMg]…[+10.0GMg][EDIT]The currently selected setting value can be edited. It will be saved after updating the setting value.[DELETE]Deletes the currently selected setting value.It cannot be deleted if there is only one registered setting value.The items that can be selected are as follows.f [YES], [NO][NOISE REDUCTION][ISO800]Switches the noise reduction effect in the range of [800BASE ISO].[NORMAL1] and [NORMAL2] are the settings emphasizing the resolution, and [SMOOTH] is the setting emphasizing reduction of noise.The items that can be set are as follows.f [SMOOTH], [NORMAL2], [NORMAL1], [OFF](Factory setting: [OFF])[ISO2500]Switches the noise reduction effect in the range of [2500BASE ISO].[NORMAL1] and [NORMAL2] are the settings emphasizing the resolution, and [SMOOTH] is the setting emphasizing reduction of noise.The items that can be set are as follows.f [SMOOTH], [NORMAL2], [NORMAL1], [OFF](Factory setting: [OFF])[LENS SETTINGS][A. IRIS LEVEL EFFECT]Sets the target value to operate the auto iris.The items that can be set are as follows.f [0]…[100](Factory setting: [50])[A. IRIS WINDOW]Selects the window to detect the auto iris.[NORMAL1] Window that is around center of the screen.[NORMAL2] Window that is around bottom of the screen.[CENTER] Window that is a spot around center of the screen.(Factory setting: [NORMAL1])[A. IRIS PEAK/AVE]Sets the ratio included in the peak for auto iris standard.The items that can be set are as follows.f [0]…[100](Factory setting: [30])