Panasonic AU-EVA1 Manual

Also see for AU-EVA1: Manual Setup guide Operating instructions

SKAARHOJ DEVICE CORESDevice: Panasonic AU-EVA1IntroductionThe Device Core “Panasonic EVA1” is used for controlling the AU-EVA1 camera. The goal of this manual isto help configuring a SKAARHOJ interface to control features available in the Device Core at this presenttime.Multicam ControlPlease notice with the release of UniSketch v2.4.16 Multicam Control have been enabled. Prior to v2.4.16only a single camera could be controlled from the Device Core. With the update up to 4 cameras can becontrolled from a single Device Core. Please see information in the section “Multicam Control”Setting up CameraIn order to control the camera a USB/Ethernet adapter must be utilized from the USB2.0 HOST port on thecamera. All communication between a SKAARHOJ interface and the camera is done via IP. Theimplementation have been done on version 0.00-00-8.02.Panasonic recommends to use Plugable USB 3.0 Gigabit Eathernet Adapter or UGREEN USB3.0 to RJ45Ethernet Adapter 202561