Panasonic AU-EVA1 Operating Instructions Manual

Also see for AU-EVA1: Manual Setup guide Manual

– 154 –Chapter 7 Output and Screen Display — Output formatItem Output Format[OUT FORMAT][FREQUENCY] [MAIN PIXEL] [SIGNAL SEL][LCD(1080p)] 1920×1080 over 59.94p*2[2048x1080] [HDMI] 1920×1080p* 1 (Factory setting)[LCD(1080p)] 1920×1080 over 59.94p*2[1920x1080] [HDMI] 1920×1080p (Factory setting)[LCD(1080p)] 1920×1080 over 59.94p*2[24.00p] [4096x2160] [HDMI] 4096×2160p1920×1080p* 1 (Factory setting)[LCD(1080p)] 1920×1080 over 60p*2[2048x1080] [HDMI] 1920×1080p* 1 (Factory setting)[LCD(1080p)] 1920×1080 over 60p*2[25.00p] [4096x2160] [HDMI] 4096×2160p1920×1080p* 1 (Factory setting)[LCD(1080p)] 1920×1080 over 50p*2[3840x2160] [HDMI] 3840×2160p1920×1080p (Factory setting)[LCD(1080p)] 1920×1080 over 50p*2[2048x1080] [HDMI] 1920×1080p* 1 (Factory setting)[LCD(1080p)] 1920×1080 over 50p*2[1920x1080] [HDMI] 1920×1080p (Factory setting)[LCD(1080p)] 1920×1080 over 50p*2*1 Displayed in the letterbox format. Quality is slightly lower compared to recorded image.*2 It will be the same image as the LCD monitor with black band in all four sides. Focus and EI assist display are possible. Equivalent to 4:2:2 (8 bits). The timecode information is not output.Following functions are not displayed.Focus square displayWaveform monitorZebra pattern when the skin tone detail function is set to enable@@ NOTEt The output will be as follows regardless of [FREQUENCY] or [MAIN PIXEL] when [SIGNAL SEL] is set to [LCD(1080p)].‑ When [FREQUENCY] is set to [59.94p]/[59.94i]/[29.97p]/[23.98p]: 1920×1080 over 59.94p‑ When [FREQUENCY] is set to [50.00p]/[50.00i]/[25.00p]: 1920×1080 over 50p‑ When [FREQUENCY] is set to [24.00p]: 1920×1080 over 60pt The 2048×1080 output is not supported.t [OUT FORMAT] will change to the factory setting when the settings of [FREQUENCY] and [MAIN PIXEL] change and current settings in [OUTFORMAT] cannot be acquired.t The output format when playing back from the thumbnail screen is as follows.‑ It will be the value set in [OUT FORMAT] when the recording resolution of the playback clip is the same as [MAIN PIXEL].‑ It will be factory setting of [OUT FORMAT] when the recording resolution of the playback clip is different from [MAIN PIXEL].t When the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [SDI RAW] is set to anything other than [OFF], and the [OUTPUT SETTINGS] menu→ [HDMI OUT] → [SIGNAL SEL] is set to [HDMI], [OUT FORMAT] is fixed to [1920x1080p].t When the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [SDI RAW] is set to anything other than [OFF], the time code information is not output.