OHAUS PA64 Service Manual

Also see for Carat PAJ1003: Instruction manual

Contents

OHAUS PA64 Service Manual Manual pdf 82 page image

CHAPTER 4 TESTINGOhaus Corporation www.ohaus.com 4-4 Pioneer™ Balances Service Manual4.4.3 Off-Center Load Adjustment for Precision ModelsNOTE:Do not attempt these adjustments unless the balance is free from drafts.The balance is very sensitive and adjustments will be affected.1. Set Auto-Zero to Off, in Menu Setup.2. Open the balance. (SeeSection 3.1.)3. Reinstall the Pan.4. Plug the power cord into thebalance and turn it on.5. Place a mass that weighs thebalance’s full capacity on thecenter of the Pan.6. Press O/T (the center button)to tare the balance and returnthe displayed weight to 0g.Move the mass to the front,back, left and right edges ofthe Pan. Note the displayedvalues.7. Correct any errors by turningCorner-load Adjusting screwsas shown in Figures 4-3 and4-4. Use a nut driver.8. Adjust as shown until thetolerance is +/-5 counts.+– +–+–+ – Figure 4-3. Off-Center Load Adjustments onPioneer Precision Balance.9. Use small adjustments, nomore than ¼ turn attime.Repeat Off-Center LoadTest.10. Turn the balance OFF.11. Remove the Platform.12. Re-assemble the balance.(See Section 3.3.11.)13. Turn Auto-Zero back to On,in Menu Setup.Figure 4-4. Off-Center Load Adjustment screwholes on Precision models.AdjustmentScrew HolesTurn in direction shown by arrows. For errorsfront to back turn both adjustments the samedirection. For side to side errors turn inopposite directions.