OHAUS PA64 Service Manual

Also see for Carat PAJ1003: Instruction manual

Contents

OHAUS PA64 Service Manual Manual pdf 62 page image

CHAPTER 3 MAINTENANCE PROCEDURESOhaus Corporation www.ohaus.com 3-38 Pioneer™ Balances Service Manual3.3.25 InCal Mechanism Installation1. Rotate the InCal Motor shaft until the Weight is in the top position.2. Slide the new InCal Mechanism into position. Fasten it with the three screwspreviously removed, but do not fully tighten them yet.3. Position the InCal Mechanism so the spacing between the InCal Weight and theInCal Weight Arms is even on both sides. (See Figure 3-105.)Figure 3-105. InCal Mechanism Alignment. Figure 3-106. Centering InCal Weight.4. Make sure the InCal Weight is lined up properly on the InCal Weight Arm. It must becentered in the slots of the Weight Arm. (See Figure 3-106.) When the WeightMechanism is properly aligned, tighten the three screws and re-check alignment.5. Test the InCal Mechanism with software. (See Section 3.3.21.EqualSpacingAdjust Spacing