OneStart

Menu

OHAUS PA313 manuals

PA313 first page preview

PA313

Brand: OHAUS | Category: Scales
Table of contents
  1. Introduction
  2. Tools and Test Equipment Required
  3. specifications
  4. Balance Operation
  5. Overview of the Display Indicators
  6. Power On
  7. The Load Cell
  8. Connecting the RS232 Interface
  9. RS232 Commands
  10. Troubleshooting
  11. Diagnostic Guide
  12. Error Codes
  13. Preventive Maintenance
  14. Variations in Opening Pioneer Models
  15. Load Cell Removal and Disassembly
  16. Disassembly of Precision Balances with Internal Calibration
  17. Removing Internal Calibration Weights
  18. Reassembling the Internal Calibration Mechanism
  19. Proper manner to grasp Load Cell when removing Weight Arm assembly
  20. Service Fixture, screws and washers for 150g to 310g Precision balances
  21. Precision Load Cell top
  22. Position Sensor Board
  23. Hanger
  24. Magnets must be clean
  27. Service Fixture for 510g to 4100g Precision Load Cell, attached to Hanger
  28. Sideways Motion Stop Plate
  30. When Position Sensor Board shows normal weight, tighten its screws
  31. Removing the InCal Mechanism from InCal Analytical Balances
  32. Bottom Housing with Load Cell, Weight Arms and Weights removed
  33. Re-Installing Internal Calibration Components
  34. Disassembling Analytical Load Cells
  35. Shims are inserted between the Hanger and the Load Cell
  36. Vertical Flexure and screws, Lock Plate, washers, and bushings, removed
  37. Hanger with two screws
  38. Contact Board with 3-wire ribbon cable soldered to it
  39. A screw connects the Contact Board to the Load Cell
  40. Position Sensor PC Board Removal/Replacement/Adjustment - Analytical
  41. Reassembling Analytical Load Cells
  42. Installing the Magnet Half
  43. Insert shims between the Hanger and the Load Cell on both sides
  44. Analytical InCal Load Cell with Top Bracket visible
  46. Block Style Load Cell
  47. Progressive Disassembly of Block Style Load Cells
  48. Internal Calibration Testing
  49. InCal Mechanism Removal
  50. InCal Mechanism Installation
  51. Removing Position Sensor
  52. Removing the Block Style Load Cell from the Base Plate
  53. Installing the Block Style Load Cell on the Base Plate
  54. Removal and Installation of the Block Style Load Cell PC Board
  55. Load Cell PCB-Temperature Sensor-Position Sensor assembly
  56. Removing the Ratio Beam on Block Style Load Cells
  57. Contact Board with cover holder off
  58. Weight Arm Screws and Washers removed
  59. Aluminum Sleeves removed
  60. Installing the Ratio Beam on Block Style Load Cells
  61. Ratio Beam Vane Slotted Area
  62. Installing the InCal Weight Arm
  63. Centering pins in Ratio Beam
  64. Installing the Load Cell PCB-Temperature Sensor-Position Sensor
  65. Position Sensor on the Magnet
  66. Setting the Up/Down Stop Screw on Block Style Load Cells
  67. Test Masses Required
  68. Performance Tests
  69. Off-Center Load Test
  70. Off-Center Load Adjustment for Precision Models
  71. Off-Center Load Adjustment for Analytical Models
  72. Off-Center Load Adjustment for Block Style Models
  73. Repeatability Test
  74. Repeatability Worksheet
  75. Linearity Test
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved