1007. MaintenanceThis section describes the simple maintenance procedures you should follow to clean the filters, the lens, the cabinet,and to replace the lamp and the filters.❶ Cleaning the FiltersThe air-filter sponge keeps dust and dirt from getting inside the projector and should be frequently cleaned. If the filteris dirty or clogged, your projector may overheat.WARNING• Please do not use a spray containing flammable gas to remove dust attached to the filters, etc. Doing so mayresult in fires.NOTE: The message for filter cleaning will be displayed for one minute after the projector is turned on or off. When the message isdisplayed, clean the filters. The time to clean the filters is set to [5000 H] at time of shipment.To cancel the message, press any button on the projector cabinet or the remote control.The two-layer filter on the projector improves cooling and dust-proof capabilities compared with the conventional models.The outsides (intake side) of the first and second layer filters remove dust.To clean the filter, detach the filter unit and the filter cover.CAUTION• Before cleaning the filters, turn off the projector, disconnect the power cord and then allow the cabinet to cool.Failure to do so can result in electric shock or burn injuries.1. Push two buttons to release the filter unit and pull it out.TIP:The following explanation uses filters (fine-texture sponge and coarse-texture sponge) attached to the projector at the time of purchase as anexample.Button2. Remove the filter cover.The filter cover is fixed at six separate mounting points.Bow the filter cover by pushing the notch slightly until it releases.NotchFilter unitFilter cover3. Remove the four filters and use a vacuum cleaner to vacuumall the dust inside.Get rid of dust in the sponge filter.NOTE:• Whenever you vacuum the filter, use the soft brush attachment tovacuum. This is to avoid damage to the filter.• Do not wash the filter with water. Doing so can result in filter clogging.Fine-texturespongeCoarse-texture sponge
