976. Installation and ConnectionsConnecting to a Wireless LAN (Optional: NP05LM series)The USB Wireless LAN Unit also provides a wireless LAN connection. To use a wireless LAN connection, you arerequired to assign an IP address to the projector.Important:• If you use the projector with the USB Wireless LAN Unit in the area where the use of wireless LAN equipment isprohibited, remove the USB Wireless LAN Unit from the projector.• Buy the appropriate USB Wireless LAN Unit for your country or area.NOTE:• The green LED on the USB Wireless LAN Unit flashes to show that the USB Wireless LAN Unit is working.• Your computer’s wireless LAN adapter (or unit) must be complied with Wi-Fi (IEEE802.11b/g/n) standard.Attaching the USB Wireless LAN UnitNOTE:• The USB Wireless LAN Unit must be inserted into the USB Wireless LAN Unit port in the correct direction. It cannot be insertedin the reverse direction. If the USB Wireless LAN Unit is inserted in the reverse direction with excessive force applied, the USBport may break.• Before touching the USB Wireless LAN Unit, touch a metallic object (such as a door knob or aluminum window frame) to dischargethe static electricity from your body.• Always insert or remove the USB Wireless LAN unit when the main power is turned off. Failure to do so may cause projectormalfunction or damage to the USB wireless LAN unit. If the projector will not work correctly, turn off the projector, disconnectthe power cord, and then connect it again.• The USB port of the projector is common use for the VIERWER. When the USB memory is installed and activate the VIEWER,you can not utilize wireless LAN.1. Press the POWER button to turn off the projector and setit into standby condition, and disconnect the power cord.2. Slowly insert the USB Wireless LAN Unit into the USB port.Remove the cap from the USB Wireless LAN Unit, and theninsert it with the surface (side of indicator) facing down. Keepthe cap for later use.NOTE:• Do not force to insert the USB Wireless LAN Unit.• Set the supplied strap onto the strap fixing hole for the measure ofanti-theft and dropping-off.Strap fixing holeTo remove the USB Wireless LAN Unit, disconnect the power cordand use the above procedure.NOTE:• The green LED on the USB Wireless LAN Unit flashes to show that Wire-less LAN Unit is working. If the USB Wireless LAN Unit is incorrectlyattached, the blue LED will not flash.• Do not press the button on the USB Wireless LAN Unit. The button willnot work with this model.USB
