494. Using the ViewerRemoving the USB memory from the projector1. Select the VIEWER start screen.Press the EXIT button with no menu displayed.2. Remove the USB memory from the projector.Make sure that the LED on the USB memory is not flashingbefore removing the USB memory.NOTE: If you remove the USB memory from the projector with a slidedisplayed, the projector may not operate correctly. If this happens,turn off the projector and unplug the power cord. Wait 3 minutes, thenconnect the power cord, and turn on the projector.USBExiting the Viewer1. Press the MENU button with the slide screen or thethumbnail screen displayed.The control bar or the pop-up menu will be displayed.2. Press the MENU button again.The on-screen menu will be displayed.3. Select a source other than [USB-A] and press the ENTERbutton.The Viewer will be exited.TIP: To exit the Viewer using the remote control, select a source otherthan [USB-A].
