926. Installation and ConnectionsConnecting an External MonitorYou can connect a separate, external monitor to your projector to simultaneously view on a monitor the computeranalog image you’re projecting.NOTE:• The AUDIO OUT jack does not support headphone terminal.• When audio equipment is connected, the projector speaker is disabled.• The signal output from the MONITOR OUT (COMPUTER) of this projector is for projecting image on exclusive one display.• When no signal is applied over 3 minutes in the condition of projector standby when NETWORK STANDBY is set in the Standbymode, output from the MONITOR OUT or AUDIO OUT terminal will be stopped. In this case pull out the computer cable and setit back after inputting video signalMonitor out and sleep mode:• The MONITOR OUT (COMP.) terminal will not work when [NORMAL] is selected for [STANDBY MODE].The MONITOR OUT (COMP.) terminal will work only in the sleep mode.Applying a signal from the COMPUTER IN terminal will put the projector in the sleep mode, which allows you to use the MONITOROUT(COMP.) terminal and the AUDIO OUT mini jack.The sleep mode is one of the standby modes. The sleep mode cannot be selected from the menu.• In the network standby mode, sound for the last viewed computer or video source will be heard.BNC-to- COMPUTER IN terminal converted signal will not be output in the standby mode and sleep mode.AUDIO OUTMONITOR OUT (COMP.)Computer cable (VGA) (not supplied)Computer cable (VGA) (supplied)Stereo mini-plug audio cable (not supplied)Stereo mini-plug audio cable (not supplied)
