NEC ME401X User Manual

Also see for ME301W: Quick start guide

Contents

NEC ME401X User Manual Manual pdf 126 page image

1158. Appendix❺ Compatible Input Signal ListAnalog RGBSignal Resolution( dots ) Aspect Ratio Refresh Rate( Hz )VGA 640 × 480 4:3 60/72/75/85/iMacSVGA 800 × 600 4:3 56/60/72/75/85/iMacXGA 1024 × 768 *1 4:3 60/70/75/85/iMacWXGA 1280 × 768 *2 15:9 601280 × 800 *2 16:10 601360 × 768 *3 16:9 601366 × 768 *3 16:9 60Quad-VGA 1280 × 960 4:3 60/75SXGA 1280 × 1024 5:4 60/75SXGA+ 1400 × 1050 4:3 60WXGA+ 1440 × 900 16:10 60WXGA++ 1600 × 900 *3 16:9 60UXGA 1600 × 1200 *4 4:3 60WSXGA+ 1680 × 1050 16:10 60HD 1280 × 720 16:9 60Full HD 1920 × 1080 16:9 60WUXGA 1920 × 1200 *5 16:10 60MAC 13" 640 × 480 4:3 67MAC 16" 832 × 624 4:3 75MAC 19" 1024 × 768 4:3 75MAC 21" 1152 × 870 4:3 75MAC 23" 1280 × 1024 5:4 65ComponentSignal Format Aspect Ratio Refresh Rate( Hz )HDTV (1080p) 1920 × 1080 16:9 50/60HDTV (1080i) 1920 × 1080 16:9 50/60HDTV (720p) 1280 × 720 16:9 50/60SDTV (480p) 720 × 480 4:3/16:9 60SDTV (576p) 720 × 576 4:3/16:9 50SDTV (480i) 720 × 480 4:3/16:9 60SDTV (576i) 720 × 576 4:3/16:9 50NOTE:• An image with higher or lower resolution than the projector’s native resolution (ME401X/ME361X/ME331X/ME301X: 1024 × 768/ ME401W/ME361W/ME331W/ME301W: 1280 × 800) will be displayed with Advanced AccuBlend.• Sync on Green and Composite sync signals are not supported.• Signals other than those specified in the table above may not be displayed correctly. If this should happen, change the refreshrate or resolution on your PC. Refer to Display Properties help section of your PC for procedures.Composite VideoSignal Aspect Ratio Refresh Rate( Hz )NTSC 4:3 60PAL 4:3 50PAL60 4:3 60SECAM 4:3 50HDMISignal Resolution( dots ) Aspect Ratio Refresh Rate( Hz )VGA 640 × 480 4:3 60SVGA 800 × 600 4:3 60XGA 1024 × 768 *1 4:3 60WXGA 1280 × 768 *2 15:9 601280 × 800 *2 16:10 601366 × 768 16:9 60Quad-VGA 1280 × 960 4:3 60SXGA 1280 × 1024 5:4 60SXGA+ 1400 × 1050 4:3 60WXGA+ 1440 × 900 16:10 60WXGA++ 1600 × 900 16:9 60WSXGA+ 1680 × 1050 16:10 60WUXGA 1920 × 1200 16:10 60*6HDTV (1080p) 1920 × 1080 16:9 50/60HDTV (1080i) 1920 × 1080 16:9 50/60HDTV (720p) 1280 × 720 16:9 50/60SDTV (480p) 720 × 480 4:3/16:9 60SDTV (576p) 720 × 576 4:3/16:9 50SDTV(480i) 720 × 480 4:3/16:9 60SDTV(576i) 720 × 576 4:3/16:9 50*1 Native resolution on XGA model (ME401X/ME361X/ME331X/ME301X)*2 Native resolution on WXGA model (ME401W/ME361W/ME331W/ME301W)*3 The projector may fail to display these signals correctly when [AUTO]is selected for [ASPECT RATIO] in the on-screen menu.The factory default is [AUTO] for [ASPECT RATIO]. To display thesesignals, select [16:9] for [ASPECT RATIO].*4 WXGA MODE: OFF*5 WXGA MODE: ON*6 RB (Reduced blanking signal) is effective up to 154MHz.