viImportant InformationPower management functionThe projector has power management functions. To reduce power consumption, the power management functions (1and 2) are factory preset as shown below. To control the projector from an external device via a LAN or serial cableconnection, use the on-screen menu to change the settings for 1 and 2.1. STANDBY MODE (Factory preset: NORMAL)To control the projector from an external device, select [NETWORK STANDBY] for [STANDBY MODE].NOTE:• When [NORMAL] is selected for [STANDBY MODE], the following terminals and functions will not work:MONITOR OUT terminal, AUDIO OUT terminal, USB(PC) port, LAN functions, Mail Alert function, DDC/CI (Virtual Remote Tool).Please refer to page 75 about details.• When [NETWORK STANDBY] has been set for [STANDBY MODE] and the LAN has been in link-down condition for 3 minutes,[STANDBY MODE] will transit into [NORMAL] automatically for the purpose to save the consumption power.2. AUTO POWER OFF (Factory preset: 1 hour)To control the projector from an external device, select [OFF] for [AUTO POWER OFF].NOTE:• When [1:00] is selected for [AUTO POWER OFF], you can enable the projector to automatically turn off in 60 minutes if there isno signal received by any input or if no operation is performed.
