NEC ME401X User Manual

Also see for ME301W: Quick start guide

Contents

NEC ME401X User Manual Manual pdf 4 page image

iiImportant InformationWARNING TO CALIFORNIA RESIDENTS:Handling the cables supplied with this product will expose you to lead, a chemical known to the State of Californiato cause birth defects or other reproductive harm. WASH HANDS AFTER HANDLING.RF Interference (for USA only)WARNINGThe Federal Communications Commission does not allow any modifications or changes to the unit EXCEPT thosespecified by NEC Display Solutions of America, Inc. in this manual. Failure to comply with this government regu-lation could void your right to operate this equipment. This equipment has been tested and found to comply withthe limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to providereasonable protection against harmful interference in a residential installation. This equipment generates, uses, andcan radiate radio frequency energy and, if not installed and used in accordance with the instructions, may causeharmful interference to radio communications. However, there is no guarantee that interference will not occur ina particular installation.If this equipment does cause harmful interference to radio or television reception, which can be determined byturning the equipment off and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio / TV technician for help.For UK only: In UK, a BS approved power cord with moulded plug has a Black (five Amps) fuse installed for use withthis equipment. If a power cord is not supplied with this equipment please contact your supplier.Important SafeguardsThese safety instructions are to ensure the long life of your projector and to prevent fire and shock. Please read themcarefully and heed all warnings.Installation• Do not place the projector in the following conditions:- on an unstable cart, stand, or table.- near water, baths, or damp rooms.- in direct sunlight, near heaters, or heat radiating appliances.- in a dusty, smoky or steamy environment.- on a sheet of paper or cloth, rugs or carpets.• If you wish to have the projector installed on the ceiling:- Do not attempt to install the projector yourself.- The projector must be installed by qualified technicians in order to ensure proper operation and reduce the riskof bodily injury.- In addition, the ceiling must be strong enough to support the projector and the installation must be in accordancewith any local building codes.- Please consult your dealer for more information.• Do not install and store the projector in the below circumstances. Failure to do so may cause of malfunction.- In powerful magnetic fields- In corrosive gas environment- Outdoors