996. Installation and ConnectionsConnection Example (3) [INFRASTRUCTURE]Connect the projector to wired/wireless LAN via wireless LAN access point.Wired LANWireless access point1. Connect a computer to the projector via wired LAN. (→ page 96)2. Use the computer’s browser to display the projector’s HTTP server. (→ page 36)3. Use an HTTP server to set the wireless LAN. (→ page 40)Select either [SIMPLE ACCESS POINT] or [INFRASTRUCTURE] for [WIRELESS] in [SETTINGS] of [NETWORKSETTINGS] and then perform detail settings in [SETTING].4. Click [APPLY] to connect to the wireless LAN.NOTE:• To use the HTTP server function, the projector must be connected to a network. First, connect the projector to a network by thewired LAN and then perform required settings for the wireless LAN on the HTTP server.• If network conflict is occurred, the STATUS Indicator starts to blink in orange. In this case, change the IP address.If you want to change the wireless LAN setting on the projector after setting it on the HTTP server, perform settingchange on the on-screen menu. (→ page 79)
