Table 4. Modem result codes (continued)Numeric Result code Description2. If dial tone detection is enforced or selected, dial tone hasnot been detected.4 ERROR Sent during an attempt to execute a command line if any of thefollowing conditions occur:1. The command line contains a syntax error.2. The modem cannot execute a command contained in thecommand line, i.e., the command does not exist or is notsupported.3. A command parameter within the command line is outsidethe permitted range.For X0, X1, X2, and X3, this message is sent instead of DELAYEDand BLACKLISTED.5 CONNECT 1200 The modem has connected to the line and either the line speed is1200 bps and DCE speed reporting is enabled, or the DTE speed is1200 bps and DTE speed reporting is enabled.6 NO DIALTONE For X2 and X4, the modem has been instructed to wait for dial toneduring dialing but none is received. When cellular phone interface isselected, indicates that cellular service is not currently available.7 BUSY For X3 and X4, if busy tone detection is enforced, the busy (engaged)signal is detected on the line when the modem is attempting tooriginate a call.8 NO ANSWER The modem is attempting to originate a call if a continuous ringbacksignal is detected on the line until the expiration of the timer S7.9 CONNECT 600 The modem has connected to the line, the DTE speed is 600 bps,and DTE speed reporting is enabled.10 CONNECT 2400 The modem has connected to the line and either the line speed is2400 bps and DCE speed reporting is enabled, or the DTE speed is2400 bps and DTE speed reporting is enabled.11 CONNECT 4800 The modem has connected to the line and either the line speed is4800 bps and DCE speed reporting is enabled, or the DTE speed is4800 bps and DTE speed reporting is enabled.12 CONNECT 9600 The modem has connected to the line and either the line speed is9600 bps and DCE speed reporting is enabled, or the DTE speed is9600 bps and DTE speed reporting is enabled.13 CONNECT 7200 The modem has connected to the line at 7200 bps and DCE speedreporting is enabled.14 CONNECT 12000 The modem has connected to the line at 12000 bps and DCE speedreporting is enabled.15 CONNECT 14400 The modem has connected to the line at 14400 bps and DCE speedreporting is enabled.16 CONNECT 19200 The modem has connected to the line and either the line speed is19200 bps and DCE speed reporting is enabled, or the DTE speed is19200 bps and DTE speed reporting is enabled.17 CONNECT 38400 The modem has connected to the line, the DTE speed is 38400 bps,and DTE speed reporting is enabled.18 CONNECT 57600 The modem has connected to the line, the DTE speed is 57600 bps,and DTE speed reporting is enabled.68 User Guide
