Replacing the solid state driveBefore you start, print these instructions.You can replace the solid state drive with a new one which can be purchased from your Lenovo reseller or amarketing representative. To replace the solid state drive, read the following prerequisites.Note: Replace the solid state drive only if you need to have it repaired. The connectors and slot of the solidstate drive were not designed for frequent changes, or drive swapping.Prerequisites for the procedureWhen replacing the drive, be sure to follow the precautions.Attention: When you are handling a solid state drive:• Do not drop the drive or subject it to physical shocks. Put the drive on a material, such as soft cloth thatabsorbs any physical shocks.• Do not apply pressure to the cover of the drive.• Do not touch the connector.The drive is very sensitive. Incorrect handling can cause damage and permanent loss of data.Before removing the solid state drive, make a backup copy of all the information on it, and then turn thecomputer off.Never remove the drive while the system is operating, in sleep (standby) mode, or in hibernation mode.To replace the solid state drive, do as follows.1. Turn off the computer; then disconnect the ac power adapter and all cables from the computer.2. Close the computer display, and turn the computer over.3. Remove the battery. For details, refer to the instructions in “Replacing the battery” on page 119.4. Loosen the screw that secures the cover of the slot (1), and then remove the cover itself (2).166 User Guide
