JVC CX-7000 Series Electronic Manual

[Printer settings] Dialog BoxSettings related to the printer.Select the checkbox for the setting item to enable, followed byspecifying a value. Doing so prints the data using the set values.When the setting is not enabled, data is printed using the preset valuesof the printer unit. .m YMC ink print levelPrint density of the YMC ink.Use the [+] values to increase, and [-] values to decrease the density.m Resin K ink print levelPrint density of the Resin K ink.Use the [+] values to increase, and [-] values to decrease the density.m UV ink print levelPrint density of the UV ink.Use the [+] values to increase, and [-] values to decrease the density.m Peel off ink print levelPrint density of the peel-off ink.Use the [+] values to increase, and [-] values to decrease the density.m Resin K ink print modePrint quality of the Resin K ink.Selecting [Fine] enhances the printing quality, but slows down theprinting speed.m MG peel modeWhen a magnetic encoder unit is installed, selecting [MG Stripe]optimizes the peeling operation of retransfer films for magnetic stripecards.m Standby modeSpecify a position when a laminator is connected.This is used for setting the standby position of the card during double-sided printing until the laminator is ready. [Front wait] is selected bydefault.m Back side coolingThis setting is only valid during double-sided printing.Setting this item may help to reduce card bend during double-sidedprinting. However, the printing time may also be affected.m RetransferSettings related to retransfer. Click on the corresponding square tochange the value.Setting a value toward the top right end increases the transfer force.However, the stronger heat also increases the deformation of the card.v TemperatureTemperature of the retransfer heating roller.v SpeedRetransfer speed.v UV speedSetting for printing the retransfer film in two panels when UV ink isused.It is used to set the speed of the retransfer heating roller duringretransfer of the UV ink.This setting helps to increase the retransfer speed without affectingthe quality of the UV print.m Bend remedySettings related to bend remedy.Click on the corresponding square to change the value.Setting a value toward the top right end increases the bend remedyforce. However, the stronger heat may have a greater impact on thecard.To disable bend remedy, select the [Disable] button.v TemperatureTemperature of the bend remedy heating roller.v SpeedBend remedy speed.Cautions:v The optimal retransfer and bend remedy settings vary according tothe card type as well as environment in which the printer is used.Adjust the setting according to the actual environment.v If the retransfer or bend remedy settings are different from the presettemperature of the printer, it may take a while before printing starts.v There is only one standard retransfer temperature. Altering theretransfer temperature on one side changes the temperature on theother side.v Bend remedy is effective when printing on only one side. Settingbend remedy to a high temperature during double-sided printing maycause the card to deform significantly.As such, select the [Disable] button during double-sided printing.v When bend remedy is disabled using the [Disable] button, the speedis automatically set to the maximum value of [+2].v The stronger the bend remedy force, the less glossy the surface ofthe remedy side will be.[Encode] Tab .Setup94