JVC CX-7000 Series Electronic Manual

m Printer iconsThe icon on the left is displayed when the printer is functioningnormally. After printing more than 1000 cards since the last cleaning,it changes to the icon display shown on the right.When the right icon appears, perform procedures in "Card FeedRoller/Heating Roller" (A page 37) under “Maintenance”. .m List of Status Display MessagesStatus DisplayMessageDescriptionPrinter is notfound.The power of the printer is not turned on, or thecomputer is not properly connected to the printer.Ready The printer is in the ready mode. The printer isready to start printing cards.Initializing Printer initializing. The printer switches to theReady mode after initialization is complete.Offline Mode The printer is in the setting mode, or rollercleaning is in progress. When this is complete, theprinter switches to the Ready mode.Preheating Preheating of the heating roller is in progress. Theprinter switches to the Ready mode uponreaching an appropriate temperature.Heating Adjusting the heating roller to the presettemperature.Card Loading The printer is printing cards. Indicates theoperating status when the printer is printing cards.After card printing is complete, the printer returnsto the Ready mode.CardTransportingNo-Contact ICEncodingContact ICEncodingMG EncodingPrintingRetransferPower Saving The printer is in the Power Saving mode, whichhelps to reduce power consumption. To exit thePower Saving mode, reset using the operationpanel of the printer.For more details, refer to" Initialization" (A page22) under "Adjusting the Printer Settings".m Media StatusDisplays the remaining space on the media.m Card QuantityDisplays the remaining card quantity as [Enough] or [None].Memo:v If [None] is displayed, replenish the cards accordingly.For more details, refer to "Cards have run out" (A page 31) under"Adjusting the Printer Settings".m Ink QuantityDisplays the remaining ink ribbon quantity in percentage in 50different levels.Cautions:v The remaining quantity is an estimated value. Differences mayoccur depending on the usage as well as media type.m Film QuantityDisplays the remaining retransfer film quantity in percentage in 10different levels.Cautions:v The remaining quantity is an estimated value. Differences mayoccur depending on the usage as well as media type.m InkDisplays the information on the loaded ink ribbon. The print counterappears blank if the ink ribbon is not correctly recognized.You may not be able to control the ink ribbon properly in this case.Check to ensure that the ink ribbon is properly installed.For more details, refer to "Installing the Ink Ribbon" (A page 60) under"Printing Media".m FilmDisplays the type of retransfer film loaded.m Print CounterDisplays the total number of cards that are correctly printed. Press the[Clear] button to reset the print counter to 0.m Printer SelectionYou can switch to the relevant printer when multiple printers areconnected to a single computer.If the printer is not found or if you want to change the search criteria,refer to "Searching a printer" (A page 114) in the “[Printer Select]Tab”.Memo:v Pressing the [Update] button searches for a connected printer andupdates the printer in the list box.v Selecting a printer from the pull-down menu switches the display tothe current status of the selected printer.m Document InformationWhen printing from the printer driver, the name of the owner anddocument are displayed.Setup109