JVC CX-7000 Series Electronic Manual

Installing the Retransfer FilmCautions:v Stand the cassette on a flat surface as illustrated in the diagram.Avoid doing so on the floor as dust attached to it may cause printingerrors. .v Do not touch the retransfer face (the side that faces outward wheninstalled) with your hand. Touching it may cause printing errors. Puton the supplied gloves when handling the retransfer film.v The cassette is heavy when the retransfer film is loaded. To preventthe cassette from dropping during handling, make sure to hold it withboth hands.v When installing a new film, make sure that at least three black linesare wound onto the take-up side. Insufficient winding may cause theprinter to malfunction.v Do not perform any work on the printer door. Do not place heavyobjects or apply load on the printer. Doing so may damage it.1 Open the printer door .2 Press and hold down the cassette button, and remove the retransferfilm cassette (on the left) .3 Install a new retransfer filmv Install while referring to the indication on the label of the cassette.A When installing the retransfer film, make sure that at least threeblack lines are wound onto the take-up side. .B With the retransfer face facing outward, align the unused side ofthe film with the arrow on the cassette, and unwind it along thethree shafts.C Insert the retransfer film firmly into the bobbin holders with the filmset to the far end of the guides.v A: take-up side (black)v B: unused side (green) .4 Remove any slack in the filmA Hold the retransfer film cassette.B Turn the knob in the direction indicated by the arrow. .5 Insert the cassette all the way in along the guide rail until a “click”sound is heard, followed by closing the printer door . .Cautions:v While in the transport mode, the retransfer film cassette cannot beinstalled to the printer with the retransfer film loaded. With the printerdoor closed, turn on the power to cancel the transport mode."Transport Mode Setting" (A page 29)Setup61