H-S81-HS Installation & Operation Manual — P/N LS10114-000HI-E:A 2/24/2015 69I/O modules Parts of the H-S81-HS System2.4.9 S81-F6001-1DescriptionThis module is used for controlling the logic and indications of a certain fireextinguishing zone in compliance with the requirements of the EN12094-1 stan-dard. It controls ten output variables and seven input variables. It controls somefire extinguishing system typical logics, such as discharge delay and reset inhibittime. This module checks the status of the inputs and outputs physically locatedon other modules by using virtual channels.Technical FeaturesStatus IndicationsThe front panel includes 8 status LEDs with the following functions:Virtual channelsThe module controls the following variables:• Safety rating: applicable up to SIL3• Redundancy: Yes• Max. output current 250mA• Automatic output protection: No• Supply voltage: 22-29VDC• Quiescent current: 10mA• Operating temperature: -5 - 50 °C• Storage temperature: -30 - 80 °C• Maximum humidity: 95% (RH) non-condensing• Hot swap capability: yesLED IndicationActivated (Red LED) Steady on under “activated” condition. It goes out in case of reset.Relised (Red LED) Steady on under “released” condition. It goes out in case of reset.Fault (Yellow LED) Flashing in case of trouble in the fire extinguishing zone.Disabled (Yellow LED) Steady on if a fire extinguishing zone is disabledInhibit (Yellow LED) Steady on under “inhibit” condition.Hold (Yellow LED) Steady on under “Hold” condition.Aut. Off (Yellow LED) Steady on under “Automatic exclusion” conditionRes. Bank (Yellow LED) Steady on when the reserve bank is selectedVariable Type DescriptionV1 In “Activated” conditionV2 In Main primary dischargeV3 In Reserve primary dischargeV4 In Main secondary dischargeV5 In Reserve secondary dischargeV6 In Intermittent audible indicationsV7 In Continuous audible indicationsV1 Out Manual activationV2 Out Automatic activationV3 Out Automatic exclusionV4 Out Emergency holdV5 Out Release inhibitionV6 Out Reserve bankV7 Out Secondary dischargeV8 Out Triggered systemV9 Out General troubleV10 Out General disable