H-S81-HS Installation & Operation Manual — P/N LS10114-000HI-E:A 2/24/2015 65I/O modules Parts of the H-S81-HS SystemConfigurationBy using the configuration program ProS81, the following parameters can be set for each outputchannel:Field ConnectionsThe module can be connected to field terminal block by using a flat or a multi-conductor cable,depending on the used bus type. S81-E2001-1 BusThanks to this bus, the module can be terminated by using a S81-T8001-1termination module with 16 terminals. S81-E2001-2 BusThanks to this bus, the module can be terminated by using a S81-CCT116-conductor multi-polar cable or a S81-T8008-1 module.S81-T8008-1Should 500 mA per line not be enough, it is possible to connect the optional module S81-T8008-1to module S81-F5003-1. The former will add 4 x 2A at 24 VDC polarity reversal outputs.Function ModeOperating mode Continuous-Normally Energized, Continuous-Normally de-energized, Intermittent,Pulsing-1, Pulsing-2, ISA-1A Alarm Sequence, Delayed on activation, Delayed onenabling, Delayed on deactivation, ANSI-S3.41, MarchTiming 1 to 255 secondsOutput type Normal / SounderOutput status in case of CPU fault Frozen in the last status / OffEnable/Disable status export to Hosts No, TCP1, TCP2, RS232Enable/Disable commands from Hosts onthe channelNo, TCP1, TCP2, RS232
