Managing the EncoderConfiguring Video EncodersMakito X User’s Guide, v2.2, Issue 02 86Video Encoder SettingsThe following table lists the Video Encoder controls and settings:Video EncoderSettingDefault Description/ValuesInputInput Select the Video Input port for the encoder:SDI BNC-1 ● BNC-1● BNC-2● BNC-3*● BNC-4*NOTE: *BNC-3 and BNC-4 only available onMakito XR.DVI DVI ● DVI (read-only)Input Format n/a This is the input signal auto-detected fromthe video source. It includes the number ofpixels per line, whether the video isinterlaced or progressively scanned(indicated by i or p), and the number offrames per second.NOTE: If the signal cannot be detected (or isoutside the supported range), the InputFormat will be Unknown.Copy ProtectedContentDVI onlyn/a (Read-only) Indicates whether or not thevideo source connected to the Makito X DVIis protecting/encrypting its output. If Yes, thestream will not be encoded.Input SettingsType Select the Video Input type for the encoder:NOTE: Automatic mode will causeincreased delay during an input switch event.To reduce the re-lock delay, set the InputType to SDI or Composite as appropriate.BNC-1 or 2 Automatic ● Automatic● SDI● CompositeBNC-3 or 4(Makito XRonly)DVI Automatic ● Automatic● Digital (HDMI/DVI)● Analog (Component/RGB)
