IntroductionPhysical DescriptionMakito X User’s Guide, v2.2, Issue 02 30Physical DescriptionNOTE For details on the Makito XR and Makito X Harsh interfaces, please refer to theInstallation Guides available through Haivision’s Download Center.Following is a description of the Makito X interfaces, connectors, and LED status indica-tors:System Interfaces (Rear Panel)The Makito X comes with a 10/100/1000 Base-T Ethernet Network interface for bothtraffic and management (RJ45).Figure 1-10 Ethernet Connection (DVI, #S/B-292E-DVI)On the Makito X with SDI, a computer can be connected to the COM1 RS-232 serial portthrough its RJ45 connector (Serial Management adapter required, see “Serial ManagementAdapter” on page 46).Figure 1-11 Serial Connection (SDI, Dual-Channel #S/B-292E-HDSDI2)NOTE The COM1 port may also be used for KLV and CoT Metadata Capture and streaminsertion (the KLV software option must be installed at the factory), as well as for bi-directional serial pass-through for controlling serially attached devices such as cameras.
