System Administration and StorageManaging the COM PortMakito X User’s Guide, v2.2, Issue 02 1963. To apply your change, click Apply.4. Click Reboot.The changes will take effect after the reboot has completed.For information on connecting a computer to the COM1 port, see “Connecting the Encoderto the Network and a Computer” on page 45.COM Port SettingsThe following table lists the COM Port settings.NOTE With the exception of the COM Port Mode, the COM Port settings are read-only.For information on modifying the COM Port settings, see “Metadata Settings” onpage 118.COM Port Setting Default Description/ValuesMode Management Selects the type of activity:• Management,• Metadata (required in order to configurethe Metadata settings), or• Pass-Through (required to control seriallyattached devices such as PTZ controlledcameras).NOTE: You must reboot the encoder whenyou change the Mode.COM Port RS-232 (Read-only) The type of Serial interface:• RS-232 or• RS-422Baud Rate 115200 (Read-only) The COM Port bitrate.Data Bits 8 (Read-only) The COM Port databits: 8Parity None (Read-only) The COM Port parity: NoneStop Bits 1 (Read-only) The COM Port stopbits: 1Flow Control None (Read-only) The COM Port flow control:Nonen/a Reboots the encoder. See “Rebooting theEncoder” on page 176.
