GE ZET3038 Owner's Manual

Also see for TRIVECTION ZET3038: Technical service guide Dimensions and installation information Installation instructions Installation instructions Service guide

GE ZET3038 Owner's Manual Manual pdf 37 page image

37Ovenlight bulbsNOTE: The glass cover should be removed only whencold. Wearing latex gloves may offer a better grip.CAUTION : Before replacing youroven light bulb, disconnect electrical powerto the oven at the main fuse or circuit breakerpanel.Be sure to let the light cover and bulb coolcompletely.For your safety, do not touch a bulb with barehands or a damp cloth. It can also shorten thebulb life.To remove:1 Turn the glass cover counterclockwise1/4 turn until the tabs of the glass coverclear the grooves of the socket.2 Using gloves or a dry cloth, remove the bulbby pulling it straight out.To replace:1 Use a new 130-volt Halogen bulb, not toexceed 50 watts.2 Using gloves or a dry cloth, remove the bulbfrom its packaging. Do not touch the bulbwith bare fingers.3 Push the bulb straight into the receptacleall the way. Then replace the screen.NOTE: The screen must be replaced orthe life of the bulb will be reduced.4 Place the tabs of the glass cover into thegrooves of the socket. Turn the glass coverclockwise 1/4 turn.For improved lighting inside the oven,clean the glass cover frequently using awet cloth. This should be done when theoven is completely cool.5 Reconnect electrical power to the oven.Care and Cleaning of the OvenTrivection ™ Wall OvenBulbSocketTabGlass coverScreenReceptacleUse glovesor clothReceptacleBE SURE ELECTRICAL POWER IS OFF AND ALL SURFACES ARE COOL BEFORE CLEANING ANYPART OF THE OVEN.How toremovepackagingtapeTo assure no damage is done to the finishof the product, the safest way to remove theadhesive left from packaging tape on newappliances is an application of a householdliquid dishwashing detergent, mineral oil orcooking oil.Apply with a soft cloth and allow to soak.Wipe dry and then apply an appliance polishto thoroughly clean and protect the surface.NOTE: The plastic tape must be removed from allchrome trim. It cannot be removed if it is baked on.