GE ZET3038 Owner's Manual

Also see for TRIVECTION ZET3038: Technical service guide Dimensions and installation information Installation instructions Installation instructions Service guide

GE ZET3038 Owner's Manual Manual pdf 12 page image

Clock, Timer and Control LockoutTrivection ™ Wall OvenTo setthe timerThe timer is an hour and minute timer only. Thetimer does not control oven operations. The maximumsetting on the timer is 9 hours and 59 minutes. To set10 minutes, enter 10. DO NOT ENTER 10:00!1 Press the TIMER ON/OFF pad.2 Press the number pads until the amountof time you want shows in the display. Forexample, to set 2 hours and 45 minutes,press 2, 4 and 5 in that order. If you makea mistake, press the TIMER ON/OFF padand begin again.To setthe clockThe clock must be set to the correct time of dayfor the automatic oven timing functions to workproperly. The time of day cannot be changedduring timed baking, a self-cleaning cycle ordelayed start time.1 Select SETTINGS.2 Select CLOCK.3 Press the number pads.4 Select ENTER.ControllockoutYour control will allow you to lock out the touch padsso they cannot be activated when pressed.NOTE: On double oven models, this activates thisfeature for both ovens.To lock/unlock the controls:1 Press the 7 and 8 pads at the same time for3 seconds, until the control screen showsCONTROL IS LOCKED.2 To unlock the control, press the 7 and 8 padsat the same time for 3 seconds, untilCONTROL IS LOCKED disappears fromthe control screen and the main menuis displayed.When this feature is on and the touch padsare pressed, the control will show CONTROLIS LOCKED.• The control lockout mode affects all touch pads.• The control will remain locked after a power failure.To resetthe timerIf the remaining time is not in the display (clock,delay start or cooking time are in the display),recall the remaining time by pressing the TIMERON/OFF pad or using REVIEW TIMES.You may change it by pressing the TIMERON/OFF pad, then press the number pads untilthe time you want appears in the display.To cancelthe timerPress the TIMER ON/OFF pad twice.3 Select START.After selecting START, SET disappears; this tells youthe time is counting down, although the display doesnot change until one minute has passed. Seconds willnot be shown in the display until the last minute iscounting down.4 When the timer reaches :00, the control willbeep 3 times followed by one beep every 6seconds until the TIMER ON/OFF pad ispressed once.12