Safety Instructions Operating InstructionsSafety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer SupportTo Set the ClockThe clock must be set to the correct timeof day for the automatic oven timingfunctions to work properly. The time ofday cannot be changed during a timedbaking or self-cleaning cycle.Touch the CLOCK pad.Touch the number pads.Touch the START pad.Make sure the clock is set to thecorrect time of day.To Set the TimerTouch the KITCHEN TIMERON/OFF pad.Touch the number pads until theamount of time you want showsin the display. For example, to set2 hours and 45 minutes, touch 2, 4and 5 in that order. If you make amistake touch the KITCHEN TIMERON/OFF pad and begin again.Touch the START pad.After touching the START pad, SET disappears;this tells you the time is counting down, althoughthe display does not change until one minute haspassed. Seconds will not be shown in the displayuntil the last minute is counting down.When the timer reaches :00, thecontrol will beep 3 times followedby one beep every 6 seconds untilthe KITCHEN TIMER ON/OFF padis touched.The 6-second tone can be canceled by followingthe steps in the Special features of your ovencontrol section under Tones at the End of aTimed Cycle.The timer is a minute timer only.The timer does not control ovenoperations. The maximum setting onthe timer is 9 hours and 59 minutes.To Reset the TimerIf the display is still showing the timeremaining, you may change it bytouching the KITCHEN TIMER ON/OFF pad,then touch the number pads until thetime you want appears in the display.If the remaining time is not in the display(clock, delay start or cooking time are inthe display), recall the remaining time bytouching the KITCHEN TIMER ON/OFF padand then touching the number pads toenter the new time you want.To Cancel the TimerTouch the KITCHEN TIMER ON/OFFpad twice.15Your control will allow you to lock out the touchpads so they cannot be activated when pressed.To lock/unlock the controls:Touch the 9 and 0 pads at the sametime for 3 seconds, until the displayshows LOC ON.To unlock the control, touch the 9and 0 pads at the same time for 3seconds, until the display showsLOC OFF.When this feature is on and the touchpads are touched, the control will beepand the display will show LOC ON. The control lockout mode affects all touchpads. No touch pads will work when thisfeature is activated. The adjustment will be retained in memoryafter a power failure.Control Lockoutge.com (U.S.)Using the clock, timer and control lockout. www.GEAppliances.ca (Canada)