Canon imageCLASS 2300 Network Manual

Also see for ImageCLASS 2300: Copying guide Specifications Basic guide Printer guide Setup

Contents

Canon imageCLASS 2300 Network Manual Manual pdf 71 page image

Setting Up a Computer for Printing4-4Using a NetBIOS Network (Windows 95/98/Me)4Installing the Printer DriverIn order to print, it is necessary to install the printer driver. (See Chapter 1, "BeforeYou Start Using This Machine," in the PCL Driver Guide.)When the screen for selecting the printer destination is displayed during printerdriver installation, select [Local Printer]. Do not select [Network Printer].The port selection can be changed after installation. You can select any port, suchas [LPT1].IMPORTANT• If the IP address range settings do not permit the IP address, you cannot install a printerdriver.• If the IP address of the computer is beyond the range of the permitted addresses in theIP Address Range Settings menu in the Remote UI, you cannot print from the computer.Setting the Printer DestinationTo set the printer destination, follow the procedure below.1 Install the NetBIOS/NetBEUI Port Monitor utility from theNetwork User Software CD-ROM provided with the machine.❑ Insert the CD-ROM into the CD-ROM drive.❑ Double-click the [My Computer] icon on the screen.❑ Right click the CD-ROM drive icon ➞ click [Open] on the pop-up menu.❑ Double-click the Portmon folder.❑ Double-click the [Setup] icon.In some environments, this icon appears as [Setup.exe].The install program starts.❑ Follow the instructions on the screen to complete the installation.NOTEDepending on the environment you are using, the CD-ROM menu may beautomatically displayed when you insert the CD-ROM into the CD-ROM drive. Inthis case, click [End] ➞ perform the procedures in this step.2 Open the Printer driver's Property dialog box.❑ On the [Start] menu, point to [Settings] ➞ click [Printer].