Chapter 11-241.2.4.2 Cleaning (LCD type) 0017-5953iR2018 / iR2022The parts that should be cleaned by the customer to maintain the design performance and the cleaning method are described below.The service engineer should instruct the customer to clean the machine at regular intervals (once a month).1. Pressure PlateClean the pressure plates [1] with a cloth dampened with water or neutral detergent and squeezed hard, and then wipe it with a dry soft cloth.F-1-222. Document Glass/Glass holder (jump board)Clean the document glass [1] with a cloth dampened with water or neutral detergent and squeezed hard, and then wipe them with a dry soft cloth.When an ADF is installed, clean is document glass (small) [2] and glass holder [3] in the same manner.F-1-233. Cleaning the Fixing Pressure RollerIf white streaks are seen on the printed paper, the fixing pressure roller can be dirty. If white streaks are seen on the printed paper, clean the fixing pressure rollerin the user mode. Be sure to clean the fixing pressure roller after replacing the toner bottle.1) Press the user mode key " " to enter the user mode.2) Using the left an right arrow keys, display the "ADJUST./CLEANING" menu.3) Press the OK key.4) Using the left and right arrow keys, select "FIX. UNIT CLEANING". Next press the OK key.5) Using the left and right arrow keys, select "CLEAN PAPER PRT". Next press the OK key. A cleaning pattern will be printed.6) Open the manual feed tray.F-1-24[6] Exterior cleaning As requiredWhen cleaning the fixing pressure roller, manually feed A4 paper.MEMO:The time required for cleaning is about 100 seconds.[1][1][2][3]
