Chapter 1010-3- The timing of transmission to UGW varies according to the device.- The timing of transmission to UGW cannot be set on the side of the device.10.1.8 Retransmission at the time of SOAP Transmission Error 0017-6741iR2022i / iR2025 / iR2030 / iR2018 / iR2022 / iR2018iIn case the SOAP transmission error occurs due to the fault at UGW side at the time of the alert code transmission, store the last 3 data failed to transmit in theRAMDISK, and retransmit it with the predefined intervals.In addition, in case the SOAP transmission error occurs at the time of the jam log or service call log transmission, retransmit the data failed to transmit with thepredefined intervals. (When transmitting these 2 types of data, RAMDISK is not used, and the number of retransmission is not restricted.)10.1.9 e-RDS Setting Screen 0017-6742iR2022i / iR2025 / iR2030 / iR2018 / iR2022 / iR2018i(1). Setting ItemsThe forms and default values of the setting items related to the e-RDS in the service mode are as follow:T-10-2(2). Screen MenuOperation list checkgetOperationListOnce every 16 hours.Upon a request from UGWSchedule information updategetConfigurationAt the time of communication testEnvironment log (Device condition log) transmissionpostEnvironmentLogOnce every 12 hours. The environment information inside thedevice such as temperature and humidity.Alert filteringgetAlertCodeNotificationListUpon a request from UGW When requested from UGW with'getOperationList'Service ModeSetting Items (Meaning) DescriptionE-RDS SWITCH e-RDS OFF/ON 0: OFF/1: ONWhen the setting is ON, transmit the counter information and error information to UGW.Default value: 0 (OFF)RGW-ADDRESS(RDS-Gateway ADDRESS)URL of UGWDefault value: the actual URL of UGWNumber of characters: 129 bytes (Including NULL. 1-byte code only)RGW-PORT(RDS-Gateway PORT)Port number of UGWDefault value: 443Setting range: 1 to 65535COM-TEST(Communication Test)Execution of communication testJudge whether the connection with UGW is established, and display the result with either 'COM-TEST OK' or'COM-TEST NG'.COM-LOG(Communication Log)Detail of the communication test resultDisplay the error log for the communication with UGW.As the error information, occurred time, error code, and error detail information are displayed.Max. number of log: 5Error information: max. 128 characters (Excluding NULL)Transmission Detail / Process Detail Transmission Timing Remarks
