Setting the User Bit76Setting the User BitThe user bit can be selected from the date or the time of recording, or an identification code consisting of8 characters in the hexadecimal system. There are sixteen possible characters: the numbers 0 to 9 and theletters A to F. The user bit is recorded with XF-AVC clips and can be output from the SDI OUT terminal(u only) and HDMI OUT terminal.Setting an Hexadecimal Code1 Open the [User Bit Settings] screen.> [3 # Recording Setup] > [User Bit Type] > [ Setting] > [i]• The user bit setting screen appears with an orange selection frame on the leftmost character.• Select [Reset] to reset the user bit to [00 00 00 00] and return to the previous screen.2 Select a character you want to change and then select [Î] or [Í] to change it as necessary.• Change the rest of the characters in the same way.3 Select [OK] and then select [X].• Select [Cancel] to close the screen without changing the user bit.Using the Date or Time1 Select [User Bit Type].> [3 # Recording Setup] > [User Bit Type]2 Select [ Date] or [ Time] and then select [X].NOTESNOTES• The user bit will not be recorded with MP4 clips recorded to the card.Operating modes:
