F. No. 2 Feeding Assembly1. Removing the No. 2 Feeding Assemblyfrom the Copier1) Remove the rear right cover, rear upper leftcover, and rear lower left cover.2) Remove the fixing motor assembly. (p. 4-21)3) Remove the fixing relay drive unit. (p. 4-28)4) Remove the E-ring q, drive belt w, drive geare, and hinge r.(Be careful not to lose the metal spacerbetween the hinge and the copier frame.)Figure 4-3775) Remove the two E-rings t and the bearing y;then, disconnect the connector u.Figure 4-3786) Remove the fixing assembly and the duplexingunit from the copier. (pp. 4-84, -52)7) Remove the two screws, and remove the deliv-ery assembly cover.8) Remove the two screws i, and move the fix-ing assembly switch assembly o to the left.Figure 4-3799) Remove the mounting screw !0, and pull outthe hinge !1 (front) used to support the front ofthe No. 2 feeding assembly.(Be careful not to lose the metal spacerbetween the hinge and the copier frame.)10)Remove the E-ring !2 from the front, andremove the bearing !3. Remove the twosprings !4, and pull out the No. 2 feedingassembly !5 toward the front.Figure 4-3804. MECHANICAL SYSTEMCOPYRIGHT © 1996 CANON INC. CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)4-5034 12 35 56 79811151413 10 1412
