III. PICK-UP/FEEDINGSYSTEMA. Multifeeder Assembly1. Removing the Multifeeder Assembly1) Remove the rear upper right cover, rear rightcover, and upper right cover.2) Remove the two screws, and remove the frontright cover.3) Remove the two mounting screws q, and dis-connect the two connectors w; then, removethe multifeeder assembly.Be sure to mark the position of the multi-feeder assembly with a scribe beforeremoving it.Figure 4-3012. Removing the Pick-Up Roller1) Remove the multifeeder assembly.2) Remove the multifeeder cover.3) Remove the two mounting screws, and removethe upper left cover.4) Remove the two mounting screws q, andremove the two multi shutter stoppers w.Figure 4-3025) Remove the three stop rings e at the front,and remove the shutter r; then, remove thepick-up roller t.(Take care not to drop the parallel pin.)Figure 4-3034. MECHANICAL SYSTEMCOPYRIGHT © 1996 CANON INC. CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)4-32Caution:wq1234 5
