8. Adjusting the Position of the Front TrayPick-Up Roller Releasing SolenoidAdjust the position of the solenoid so that thedistance from the center of the solenoid mountingplate and the solenoid is 19.8 ±0.3 mm.(To facilitate the work, you may remove thefront pick-up roller releasing solenoid assembly.)Figure 4-3539. Adjusting the Position of the Front TrayReleasing SolenoidInstall the solenoid so that the claw edge of thelatch lowers 14 mm or more when the plunger ofthe solenoid is pushed in.(To facilitate the work, you may remove thesolenoid from the copier.)Figure 4-354D. Pick-Up Vertical Path RollerAssembly1. Removing the Pick-Up Vertical Path Rollerfrom the Copier1) Remove the copier’s rear right cover.2) Remove the scanner motor controller PCB.3) Rotate the pulley q, and fix it in place so thatthe flat portion of the pulley and the gear w willnot interfere.Figure 4-3554) Remove the E-ring e, pulley r, parallel pint, E-ring y, and bearing u in the order indi-cated.(Be careful not to drop the parallel pin.)Figure 4-3564. MECHANICAL SYSTEMCOPYRIGHT © 1996 CANON INC. CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON) 4-4319.8±0.3mm14 mmor moreLatch clawPlungerAdjustingscrews2173456
